Water Meter MNK-ST

Water Meter MNK-ST

Water Meter MNK-ST

Multi-jet wet dial meters for cold water in a standpipe design
For installation in vertical pipelines with an upwards flow direction, the high quality MNK wet dial measuring insert is available in a standpipe housing.
The MNK-ST water meter is designed for standpipe installation and guar- antees an uncomplicated calibration replacement. In comparison with a vertically installed standard water meter, the register keeps on functioning, even in a horizontal position. Thanks to the resulting decrease in bearing load, a significant improvement in the long-term measuring reliability can be achieved.
Version MNK-N-ST is retrofittable with pulser (reed) for remote readout.

  • Measuring Principle: Multi-Jet Meters
  • Length without connectors:
    • 105 mm
    • 150 mm
    • 200 mm
  • Housing Material: Brass
  • Register: Wet Dial
  • Nominal Flow Q3 (≈ Qn):
    • Q3=2,5 (≈ Qn 1,5)
    • Q3=4 (≈ Qn 2,5)
    • Q3=6,3 (≈ Qn 3,5)
    • Q3=10 (≈ Qn 6)
    • Q3=16 (≈ Qn 10)
  • Nominal Diameter DN (mm):
    • DN 20
    • DN 25
    • DN 32
  • Temperature:
    • Cold water up to 50° C
  • Specified Units on Display: Cubik Meters (m³)
  • AMR Technologies: Reed Pulser
  • Metrological Class horizontal (max.): R 200
  • Operating pressure (max.): MAP 16

-For the consumption measuring of cold potable water up to 50° C
-Water meter for standpipe installation

Retrofittable with pulser (Standard pulse value 10 l/Imp., optional 100 l/Imp.)
- Radio via PDC-radio module:
- Wireless M-bus (according to OMS)
- Radio via LPWAN (LoRaWAN™, SIGFOX