Bulk water meter Zenner WPH-N

Bulk water meter WPH-N

Bulk water meter WPH-N

View

Woltman meter with parallel turbine shaft for hot sanitary water up to 90° C The WPH-N water meter by ZENNER is always used when high flow rates with a relative constant flow rate profile are to be measured.
Through its robust construction they not only are capable of covering a large measuring range, but the measuring accuracy is also long-term stable. The hydrodynamic optimized turbine is reliably operated already at small flow rates and “upwards” it has enough power reserves to reliably measure flow rate peaks. Especially strong bearings with low friction guarantee a long life of the meter.
Reed sensors, optical and inductive-NAMUR sensors can always be retrofitted without damaging the calibration seal. Then the meter can be integrated with data communication or automation and control systems in a simple and flexible way.

  • Principio di misurazione: contatore woltman parallelo
  • Length without connectors:
    • 200 mm
    • 225 mm
    • 250 mm
    • 300 mm
    • 350 mm
    • 450 mm
    • 500 mm
    • 600 mm
    • 800 mm
  • Housing Material Cast: Iron
  • Register: Dry Dial
  • Nominal Flow Qn:
    • QN 15
    • QN 25
    • QN 40
    • QN 60
    • QN 100
    • QN 150
    • QN 250
    • QN 400
    • QN 600
    • QN 1000
    • QN 1500
  • Nominal Diameter DN (mm):
    • DN 40
    • DN 50
    • DN 65
    • DN 80
    • DN 100
    • DN 125
    • DN 150
    • DN 200
    • DN 250
    • DN 300
    • DN 400
    • DN 500
  • Temperature:
    • Hot sanitary water up to 90° C
  • Specified Units on Display: Cubik Meters (m³)
  • Additional Options: Copper Can (IP 68)
  • Metrological Class horizontal (max.): B
  • AMR Technologies:
    • Reed Pulser
    • Opto Sensor
    • Namur Sensor
    • Hall Sensor
    • Encoder
  • Operating pressure (max.): MAP 16